Vancouver Roof Pros provides professional chimney flashing in Vancouver, WA for residential and commercial properties across Clark County. A chimney is a wall built up through a hole in the roof, which is a strange thing to ask a roof to accept, and it generates more leak calls than any other detail we work on. On a shaded slope it is worse, because it blocks everything coming down.
The failure is almost always the flashing rather than the masonry. Step flashing should be individual pieces, one per course, each lapping the one below and turned up the chimney at least four inches, then covered by counterflashing bedded into a reglet ground out of the mortar joint and sealed. What we usually find instead is a continuous L-shaped strip and a lot of roof cement, which lasts a few years and then cracks along every movement joint.
The upslope side needs a cricket. A chimney more than roughly thirty inches wide across the slope has to carry a saddle behind it, framed and flashed, to split the water and push it around. Without one the back pan collects needles, moss debris and water, holds all of it against the masonry, and no amount of sealant is going to hold that back over a wet Clark County winter.
Masonry gets its own inspection while we are up there. On the shaded side of a chimney, moss and lichen colonise the mortar joints, hold moisture in the joint face, and accelerate freeze-thaw damage in the handful of hard frosts we get each year. Repointing before that opens up costs a fraction of a rebuild above the roofline.
Crowns and chase covers are the other regular offender. A thin mortar wash crown cracks and lets water down into the chimney core, and a flat galvanised chase cover on a framed chimney ponds and rusts through from the top. Both are replaceable while the roof is being worked on: a cast crown with a drip edge and overhang, or a stainless or aluminium cover with a proper cross-break.
If a chimney is no longer used, taking it down to the roof plane and decking over is often the cheapest permanent answer. It is less work for us than rebuilding one, and it removes the detail altogether rather than committing you to maintaining it forever. Clark County permitting for that is straightforward, and we handle the paperwork as part of the job.
Our licensed and insured team brings the right materials and equipment to every job — moss rhizoids wedged under the shingle butt edge, the factory sealant strip bond between courses, north-slope drying potential under a conifer canopy, 1x4 skip sheathing left from an original cedar shake roof, hand removal with a plastic-bladed shingle scraper, potassium salts of fatty acids moss treatment — and backs the work with a written workmanship warranty. We serve Vancouver and nearby communities including Camas, Washougal, Battle Ground, Ridgefield.
What We Handle
Everything our chimney flashing in Vancouver covers
One crew, one point of contact, and the full range of chimney flashing work in Vancouver, WA. If it is on this list we do it in house rather than handing it to a subcontractor:
- chimney flashing repair vancouver wa
- chimney leak repair clark county
- step flashing chimney washington
- counterflashing reglet vancouver
- chimney cricket saddle installation
- chimney crown repair wa
- masonry chimney leak vancouver washington
- chimney flashing replacement cost
- chimney chase cover metal
- chimney repointing roofline
- chimney flashing contractor clark county
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Vancouver services.
Materials, equipment and how we do chimney flashing
The difference between chimney flashing that lasts and chimney flashing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with moss rhizoids wedged under the shingle butt edge, the factory sealant strip bond between courses, north-slope drying potential under a conifer canopy, 1x4 skip sheathing left from an original cedar shake roof, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Vancouver job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in Clark County means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do chimney flashing outside Vancouver
Vancouver Roof Pros covers Vancouver and the surrounding communities of Clark County. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Chimney Flashing in Camas, WA — Clark County, population 26,065
- Chimney Flashing in Washougal, WA — Clark County, population 17,039
- Chimney Flashing in Battle Ground, WA — Clark County, population 20,743
- Chimney Flashing in Ridgefield, WA — Clark County, population 10,319
- Chimney Flashing in Salmon Creek, WA — Clark County, population 21,293
- Chimney Flashing in Hazel Dell, WA — Clark County, population 23,569
Start on the Vancouver Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Vancouver Chooses Vancouver Roof Pros
- ✓We grade the north and south exposures as two separate roofs and price them separately
- ✓We quote single-slope tear-offs, which most roofing companies in Clark County will not
- ✓We will not write a replacement estimate for a roof that is only stained
- ✓We refuse retrofit zinc strips and shingle coatings that hide moss damage instead of fixing it
The standards behind chimney flashing
Quality here is not a matter of opinion — it is written down. The chimney flashing work we do in Vancouver follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every chimney flashing project in Vancouver gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free chimney flashing free estimate in Vancouver, or request a quote and we'll get right back to you.